Using the scissors, cut the plastic wrapt over the print head

strato001Move back the print head to remove the protection foam

strato003

strato004

Cut the plastic wrapt over the tray

strato002

Turn the screw to raise the tray and remove the foam

strato005

Remove the two protection foams

strato006

strato007

Connect the power supply to the back of the 3d printer

strato008

Connect the power supply

strato009

If you have an Ethernet network, you can connect your 3d printer to the network throw a second slot on the machine’s back. You will need an Ethernet wire.

strato047

Apply power to the 3d printer, use the switch on the front side

strato010

The button will light up in blue and the touch screen will turn on. After one minute, the menu will show on the screen and the 3d printer will be ready

strato011

home

In the home page, click on the icon « SETTING »

setting

Click on the icon « CONNECTION »

settings

Check that your IP is showed on the right circle.

strato048

You can also choose the wifi mode:
In the home page menu, click on the icon « SETTING »
Click on « CONNECTION » and choose « CONNECT TO AVAILABLE NETWORK »

connection

If your wifi network doesn’t show, click on the icon « RESET »

strato050

Once your wifi network is on the list, click on the blue icon on the left of your network

strato051

A touchpad will appear to insert your network’s password

wifi_connection_2

Now, you are connected to your wifi network

strato052